Track Saw Square Trax90 for Makita Guide Rail ABS 90 Degrees, StealthMounts

Quick Facts — StealthMounts Trax90 for Makita

• Brand: StealthMounts
• Model: TSS-S-MK-1
• Fits: Makita guide rails
• Function: Sets the rail at exactly 90 degrees to the board edge
• Material: Injection moulded ABS plastic
• Quantity: 1 pc
• Made in Great Britain

The StealthMounts Trax90 turns squaring the guide rail into one motion: the square couples into the groove of the Makita rail, the fence sets against the board edge — and the rail lies at exactly 90 degrees, ready for the cut. No measuring from two references, no checking square afterwards.

The Trax90 is injection moulded in ABS and travels with the rail in the saw bag. Made in Great Britain. Genuine product, supplied through official European distribution.

How the Trax90 works against the board edge

The square makes the edge the reference: the Trax90 sits in the rail groove with its fence at a right angle, so when the fence presses against the board edge the rail lands square automatically — every time, however rushed the job. Mark the cut, slide the rail to the line with the square still on, and the cut comes out straight without double measuring.

Where does the Trax90 earn its place?

Cutting sheet goods on site where there is no saw table and every cut happens on trestles: shelf panels, wardrobe sides and boards where a crooked cut shows in every joint. In the joinery it speeds things up too — the routine 90-degree cuts go straight off the edge while the try square is saved for check measuring.

Technical Specifications

Suitable for: Tradespeople, service technicians, installers and anyone running several tool batteries.

Industries: Construction, electrical, plumbing, vehicle service and mobile workshops.

Frequently Asked Questions (FAQ)

Which guide rails fit the StealthMounts Trax90 TSS-S-MK-1?

Makita guide rails — the square couples into the groove profile of the Makita rail. For Festool rails the Trax90 exists in a Festool version, and for wide boards there is the Trax90 XL with a longer fence; rails from other makes need their respective versions.

How accurate is the angle with the Trax90?

The fence is moulded at a right angle to the rail coupling, so the precision comes from the mould and repeats cut after cut — provided the fence sits clean against a straight board edge. Check the edge on rough-cut boards; a damaged reference edge gives errors whatever the tool.

What sets the Trax90 apart from measuring the cut with a tape and try square?

The steps: with the tape you measure two points, lay the rail between them and check square afterwards — three stages where errors creep in. The Trax90 does it all in one: fence to edge, rail square, cut. On a day of twenty sheet cuts that is the difference between measuring work and sawing work.