Your Cart

Ultrasonic Cleaners & Parts Washers

Ultrasonic cleaners and parts washers for the workshop

This category covers ultrasonic cleaners and parts washers for cleaning engine parts, carburettors, injectors, bearings, tools and other components. They remove oil, grease, soot and dirt faster and more evenly than cleaning by hand, saving time in car workshops, machine servicing and industry.

An ultrasonic cleaner suits small, intricate parts with channels and cavities. A parts washer is used for larger, dirtier parts that are brushed and rinsed clean.

 

Ultrasonic cleaner or parts washer – which do you need?

  • Ultrasonic cleaner: sound waves in the liquid create microscopic bubbles that loosen dirt even in tight channels, threads and cavities a brush cannot reach. Used for carburettors, injectors, chains, small parts, jewellery and electronics. Many models have heating and a timer.
  • Parts washer: a tank with a pump that circulates cleaning fluid through a brush or flush tube. The part is scrubbed and rinsed by hand, and the fluid is reused. Used for engine parts, gearbox parts, brake components and larger assemblies.

 

How to choose the right model

Tank size: choose a tank in which the largest part you clean fits fully below the liquid surface. Ultrasonic cleaners are usually sized in litres and parts washers by tank dimensions or volume.

Heating and timer: heated liquid dissolves grease and oil faster in an ultrasonic cleaner, and a timer switches the unit off when the cycle is complete.

Cleaning fluid: use a fluid intended for the machine and for the material of the parts. Water-based degreasers are common in both types.

 

Frequently asked questions about ultrasonic cleaners and parts washers


What is the difference between an ultrasonic cleaner and a parts washer?

An ultrasonic cleaner cleans parts automatically with sound waves and reaches into channels and cavities, which suits small, intricate parts. A parts washer has a pump that circulates fluid through a brush, and parts are cleaned by hand, which suits larger, dirtier components.

Can carburettors be cleaned in an ultrasonic cleaner?

Yes, carburettors are one of the most common uses for an ultrasonic cleaner. The ultrasound loosens deposits in jets and channels that are hard to reach with a brush or compressed air. Rubber parts and gaskets should be removed before cleaning.

What fluid should be used in an ultrasonic cleaner?

Use a cleaning fluid made for ultrasonic cleaners, usually a water-based degreaser. Flammable solvents such as petrol or lighter fluid must not be used in an ultrasonic cleaner. The best fluid depends on the type of dirt and the material of the parts.

What size ultrasonic cleaner do I need?

The tank should be large enough for the biggest part you want to clean to sit fully below the liquid surface without resting directly on the bottom. Small tanks are enough for injectors, small parts and tools, while carburettors, engine covers and larger components need a bigger tank.

There are no products to list in this category.