Car Ramps with Hydraulic Jacks 5 t, 2 pcs, Wuber Tools

Quick Facts — W22055 Car ramps with hydraulic jacks

• Model: W22055
• EAN: 5906436763456
• Type: Car ramps with hydraulic jacks, 2 pcs
• Jack capacity: 5 t
• Lifting range: 240-350 mm
• Locking levels: 260, 300, 335 mm
• Ramp width: 26.5 cm

Car ramps with hydraulic jacks, supplied as a set of two ramps, each with an integrated hydraulic cylinder rated at 5 t. The set is built for underbody work such as oil changes, exhaust inspection and fitting engine guards. The Wuber Tools ramps are made of 3.5 mm sheet steel on an angle-iron frame.

The lifting range is 240-350 mm and the vehicle can be secured mechanically with locking pins at three levels. Ramp load capacity is 2 t per pair.

What makes car ramps with hydraulic jacks a strong choice for underbody work?

The cylinder in each ramp raises both sides of an axle in parallel and stably, and a safety valve in the jack stops the work when the load limit is exceeded. Lowering is controlled by a release valve on the handle, giving a smooth and predictable descent.

The sheet is 3.5 mm thick and the frame is angle iron, so the ramps keep their shape under load. The ramp width is 26.5 cm and the approach angle 16°, giving a gentle drive-on that reduces the risk of the bumper catching.

Where car ramps with hydraulic jacks perform best

The ramps are used for work under the vehicle that needs access to the underbody, for example:

• oil changes with the locking pin in the chosen position (260, 300 or 335 mm)
• exhaust system inspection
• fitting engine guards
• home garage work where a lifting range of 240-350 mm is enough

The 12 mm locking pins hang on chains at the columns and are always within reach during work.

Technical Specifications

Package Contents

• Car ramp with hydraulic jack, 2 pcs
• Jack handle, 2 pcs
• Locking pin 12 mm on chain, 4 pcs
• Original packaging

A fit for: Car mechanics and tyre fitters.

Typical settings: Car workshops and tyre workshops.

Frequently Asked Questions (FAQ)

Can the car ramps with hydraulic jacks 5 t carry more than 2 t per pair?

No. The jack is rated at 5 t, but the ramp load capacity is 2 t per pair. The car ramps with hydraulic jacks W22055 must therefore not be loaded above 2 t.

How high do the car ramps with hydraulic jacks lift and how is the load secured?

The lifting range is 240-350 mm. The car ramps with hydraulic jacks W22055 are locked mechanically with 12 mm locking pins at three levels: 260, 300 and 335 mm.

What sets the car ramps with hydraulic jacks 5 t apart from other car ramps?

Each ramp has its own hydraulic cylinder, so the vehicle is raised on the ramps rather than just resting on them. The load is also secured mechanically with locking pins at three levels (260, 300 and 335 mm), and a safety valve stops the work when overloaded.